North County · 92870

Appliance Repair in Placentia

Placentia is single-storey post-war tract housing almost end to end, and the laundry is generally still where the builder put it. Same alcove, same hookups, same standpipe. When one house on a street has a drain or a vent problem, the neighbours usually recognise the description.

What is different about Placentia

Original hookups set the boundaries here. A laundry alcove drawn for a narrow pair will not take a modern machine with its door swung open, the dryer outlet is frequently still three-prong, and the vent leaves through the side of the garage with two or three elbows in the run. Hard water is the other constant across these tracts: scale on a washer’s inlet screens shows up first as slow fills, which the control reads as a fault and reports as one. Most of what we do in Placentia is restore an original installation rather than argue with it.

Repairs we take on in Placentia

Elsewhere in North County

From Placentia and nearby

5 from 1,626 reviews

  • Electric dryer tumbled without heat. One half of the element was open and the thermostat had also failed. Both changed, and he cleared the vent run out to the exterior wall while he was there.

    Trent G.Placentia★★★★★

  • Flipping the switch produced nothing from the disposal. Not the reset, not the wall switch, the motor had seized. He fitted a replacement, checked the dishwasher inlet, and cleaned up under the sink afterwards.

    Vivian K.Placentia★★★★★

  • Top loader kept stopping partway with the drum full. The drain hose had kinked behind the machine and the pump was straining. He rerouted the hose, cleaned the pump, and it finishes cycles again.

    Neil R.Placentia★★★★★

Placentia questions

The washer fills slowly and then stops. Is the valve failing?

Sometimes, but the screens come first. In these tracts the inlet filters scale up, the fill takes longer than the control expects, and the machine calls it a fault. Cleaning or replacing the screens and the valve is modest work. A board reading a failing pressure sensor is the other common cause.

Can I still use a three-prong dryer cord?

If the outlet in the house is three-prong, the cord has to match it, and changing a cord to suit a new dryer is normal work. What is not acceptable is adapting one type to the other. If the outlet itself is damaged or scorched, that is an electrical job before the dryer goes back.

Why does the disposal keep resetting itself?

A disposal that trips its own overload within seconds is nearly always jammed rather than dead. Something hard has lodged between the impeller and the shredder ring, or the bearings have seized after a long soak. We free it, check the flywheel turns cleanly, and only then look at the motor.

Booking a visit in Placentia

Say what the appliance is, what it is doing, and roughly when it started. That is usually enough to know what the visit involves before anyone sets off.

(949) 979-4880 Book online

$89 to come out, and nothing extra on top once a repair is agreed.